Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for Fishtown Homeowners
Most chimney problems in Fishtown show up where water gets in and stays: a cracked crown, a bad flashing seam, brick that has gone soft over a few winters. Repairs aren’t about cosmetics. A chimney that’s taking on water sends it down into the flue and the surrounding structure, and that’s when a small fix turns into a rebuild. Our technicians have up to 13 years of experience diagnosing exactly this kind of damage, and they work on the whole system rather than one piece of it. Call (833) 432-4886. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Same-day visits are often possible when you call early, so the assessment happens before the damage spreads.
What Our Chimney Repair Service Includes
Mortar Repointing
Repointing means cutting out worn mortar joints and packing in fresh mortar, so the brick is held properly again. You need it when the joints between the bricks have eroded enough that the wall feels loose or water can sit in the gaps. We match the mortar to the chimney’s existing mix and repoint the full area that needs it, not just the joint a passerby can see from the sidewalk.

Spalling Brick Repair
Spalling is brick that has flaked, pitted or cracked at the face, usually after repeated freeze-thaw cycles with moisture trapped inside. Once the face is gone, the brick keeps absorbing water and the damage spreads to the bricks beside it. We identify which bricks have failed, replace those, and address the moisture path that caused it in the first place.

Chimney Waterproofing
Waterproofing is a breathable coating that keeps rain out of the masonry while letting moisture inside escape. It’s the right call for a chimney with sound brick that keeps taking on water anyway, and it’s also what protects fresh repairs from a repeat. We apply a vapor-permeable treatment after any masonry work has fully cured, so the chimney dries rather than trapping damp in the wall.

Flashing Repair
Flashing is the metal that seals the seam where the chimney meets the roof, and it’s one of the most common places a Fishtown roof leak starts. When the flashing pulls away, corrodes or was installed without proper step and counterflashing, water runs straight down the chimney chase into the house. We repair or replace the flashing with Copperfield-sourced components and tie it into the roof correctly.
Chimney Rebuilding
Rebuilding replaces the parts of the chimney that are too far gone to repair, from a new crown and top courses down to the section above the roofline. It’s needed when the brick is crumbling through the wall, the crown is cracked beyond patching, or a previous repair only covered the surface. We take down and rebuild the affected section with new brick and proper footings for the crown, so the finished chimney is structurally sound and not just capped over.
Tuckpointing
Tuckpointing is a finer version of repointing, finished for appearance as well as weatherproofing, and it’s used where a chimney face is visible and doesn’t need full rebuilding. It’s worth doing when the mortar joints are still structurally sound but the surface is weathering, or when a chimney needs to look right on a visible side of the house. We match the mortar color and profile to the surrounding brickwork, which takes care and patience but makes a real visual difference.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
We work with a curated set of professional-grade product lines, and we name them so you can look them up yourself instead of taking our word for it. On the resurfacing side we use HeatShield, the ceramic liner restoration system that repairs a damaged flue interior without tearing out the old liner. For flexible liners on older homes where a rigid liner won’t fit, we install DuraFlex. Caps and covers come from Gelco and Famco, and we source structural and flashing components through Copperfield, the professional distributor many certified sweeps buy from. Those are the brands behind the work.
Knowing these product lines well means we know where each one fails and how to fix it properly rather than patching around it. A HeatShield application that was done wrong looks fine for a season and then delaminates, and a cap that was installed without enough overhang lets water drive back against the crown. We correct those failures as well as diagnose new ones. If you want the whole chimney looked at rather than one section, start with a chimney sweep and we’ll flag anything the sweep turns up, whether you have DuraFlex, HeatShield, Gelco, Famco or another make entirely, we can help.
Signs You Need Chimney Repair Right Now
- Crumbling mortar or loose bricks. If joints are soft enough to dig out with a screwdriver, or a brick moves when you press it, the chimney is losing structural hold. Patching over it hides the problem while the wall keeps weakening, so it’s worth getting looked at before the next hard freeze.
- White chalky stains on the brick. That’s efflorescence, salt pushed out of the masonry by moisture moving through it. It usually means water is getting in somewhere up top, and if it keeps coming back after a cleaning, the source needs finding.
- Rust on the damper or firebox. A rusty damper is a strong sign water is coming down the flue. Left alone it can seize the damper open or shut and start corroding the metal parts of the chimney structure.
- Water stains on the ceiling near the chimney. Staining on the ceiling or the chimney breast inside the house means water is already through the roof line. This one moves fast, so it’s worth a call promptly rather than waiting for the next rain.
- Cracked or tilted crown. The crown is the concrete cap at the top that sheds water away from the flue. Once it cracks, water goes straight into the chimney instead of around it, and a crown that has shifted or crumbled is one of the most common reasons a chimney keeps leaking.
Our Chimney Repair Process – Step by Step
- 1
We take the call and book the assessment. Tell us what you’ve noticed, whether that’s a leak, loose brick, or a smell. We’ll book a visit and, when you call early, often fit it in the same day.
- 2
We inspect the whole system, inside and out. That means the firebox, damper, flue and the exterior masonry, plus the roof line where the flashing sits. Where a flue needs a closer look, we run a camera so we can see the liner interior and photograph what we find.
- 3
We show you the evidence and explain the options. You see what we see, whether that’s a crack in the crown, a failed flashing seam, or a liner that’s broken up. We’ll lay out what needs fixing, what can wait, and what each option looks like.
- 4
You get a written estimate. The estimate sets the price for the job, with no surprises added later. We don’t recommend work we can’t show you a reason for.
- 5
We do the work and check it before we leave. Masonry repairs, waterproofing, flashing and rebuilding are all done on site, and we inspect the finished job to make sure the repair actually solves the problem you called about.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in Fishtown?
Most chimney repair jobs in Fishtown fall into a few common ranges, and we can usually narrow it down once we’ve seen the chimney. A typical repointing or tuckpointing job on a standard chimney runs $400 to $1,200, depending on how many joints need work and how high the chimney is. Spalling brick repair, where individual bricks are replaced, tends to land in the $500 to $1,500 range, and full chimney waterproofing runs $300 to $900 depending on size and how much prep the surface needs. Flashing repair is usually $250 to $700, and a full chimney rebuild, the most involved job on the list, runs anywhere from $2,000 to $8,000 depending on how much of the chimney comes down and goes back up.
The main things affecting price are the height and access of the chimney, how much of the masonry has actually failed versus just weathered, and whether we’re treating one problem or a few connected ones. Water damage in particular tends to come as a set, so a leaking crown and a failed flashing and worn mortar often turn up together. To avoid overpaying, the most useful thing you can do is get the problem properly diagnosed before any work starts rather than buying one repair at a time and finding the water still coming in. The written estimate sets the final price, and it’s yours to review before we start. Nothing gets recommended without camera or photo evidence you can see for yourself, and we’ll tell you plainly when work can safely wait.
Chimney Repair Near Fishtown – Our Service Area
We work across Fishtown and the surrounding neighborhoods, including Kensington, Port Richmond, Northern Liberties, Hunting Park and Kensington’s surrounding streets, plus Delaware County towns like Aldan, Sharon Hill, Collingdale, Clifton Heights, Drexel Hill, Colwyn and Haverford College. Same-day visits are often possible when you call early in the day. Where an inspection turns up a liner or flue problem on top of the masonry work, we handle the repair in one visit. You can read more about our chimney repair approach in Fishtown, or about chimney repair in Aldan and chimney repair in Sharon Hill.
Serving Fishtown, PA – Our Local Coverage Area
We serve Fishtown and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in Fishtown
Chimney repair covers the work that keeps a chimney structurally sound and watertight, from repointing mortar and replacing spalled brick to repairing flashing, waterproofing the masonry and rebuilding the upper section when it’s too far gone. It’s different from a sweep, which cleans the flue, and from a liner installation, which handles the inside of the flue. If you’re not sure which one you need, we start with an inspection and tell you what the sweep or the camera shows.
A repointing or flashing repair is often done in a day, while waterproofing or larger masonry work usually takes a couple of days, and a full rebuild can run several days depending on the size of the chimney. Weather matters, so we’ll give you a realistic timeline in the written estimate rather than a guess on the phone. Call (833) 432-4886 for an exact quote – estimates are free.
Most repair jobs range from about $250 for a flashing repair up to $8,000 for a full rebuild, with repointing and brick repair typically between $400 and $1,500. The range is wide because the actual cost depends on what’s failed and how high the chimney is. Call (833) 432-4886 for an exact quote – estimates are free.
Yes, we work with both HeatShield ceramic resurfacing and DuraFlex flexible liner systems, and we’re trained on applying them correctly rather than just installing generic parts. If a previous resurfacing job has delaminated or a liner has failed, we diagnose the cause before recommending a fix. We also install Gelco and Famco caps and source components through Copperfield, so the products behind the repair are ones you can look up.
Same-day visits are often possible when you call early in the day, depending on the schedule. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed on Saturday. A call outside dispatch hours is booked into the next opening.
Our repairs are backed by our satisfaction guarantee, and the written estimate spells out what’s covered for each type of job. Masonry and waterproofing work is done with the intent that it holds up through the seasons here, not just until the next rain. Ask us at the estimate stage and we’ll walk you through what applies to your repair.
Clear the area around the fireplace and hearth and make sure we can get to the roof access point, whether that’s through an attic hatch or an outside access. Move anything fragile out of the path from the door to the chimney. If you have a gas log set or insert, tell us when you book so we come prepared for the specific setup.
Schedule Your Chimney Repair Service in Fishtown Today
If a leak, a crumbling crown or soft mortar has been on your list, the sooner it’s diagnosed, the smaller the repair usually is. We inspect the whole chimney, show you the evidence and give you a written estimate with the price set per job. Nothing gets recommended without camera evidence. Call (833) 432-4886. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free.
Written by the team at Chimney Sweep Fishtown.