Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Sweep Across Sharon Hill
If you live in Sharon Hill and the fireplace has started smoking back, or the damper feels stiff, or the cap on your chimney looks like it lost a fight with the weather, we can help. We’re Chimney Sweep Fishtown, and we work on chimney and fireplace systems across this part of Delaware County – the rowhouses and twins on narrow lots, the shared party-wall stacks, the factory-built inserts sitting inside old brick chases. Sharon Hill is close-in and densely built, which shapes how we work here. Nothing is a textbook clean-and-go job. Call (833) 432-4886 and we’ll book a sweep with a written estimate.
Why Sharon Hill Homeowners Call Chimney Sweep Fishtown for Chimney Sweep
Most of the work on a chimney sweep in this borough starts with diagnosis, not scraping. Homes in Sharon Hill are predominantly early- to mid-1900s rowhouses, twins, and small detached singles, and many of those flues were built for coal or early oil heat. That means a factory-built fireplace insert dropped into an original brick chase has to be checked at both ends: the insert against its manufacturer spec, and the century-old masonry around it that nobody has looked at in decades.
We name the materials we use, so you can research them yourself. That means DuraFlex flexible liners for retrofits where a rigid liner won’t fit, HeatShield ceramic resurfacing for a flue that’s pitted but structurally sound, and Gelco and Famco caps specified as weather protection. Our technicians have up to 13 years of experience across the sweep-to-rebuild range. We answer 24/7, and we can get fast dispatch from 7am to 7pm, Sunday through Friday, to this part of Delaware County.
Local knowledge matters most on the roofline. Because so many Sharon Hill stacks are shared between twins and rowhouses, a flue defect on one side of a party wall can quietly affect the neighbor’s unit. Our technicians routinely check both addresses on a single stack before signing off on a job. That’s the kind of thing you only learn by working these roofs.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Sweep Services in Sharon Hill
From sweep to rebuild, we cover the whole chimney system so you aren’t handing off between contractors. Here are the four services Sharon Hill homeowners call us for most.
Level 1 Inspection
A Level 1 inspection is the annual read-and-check visit. We look at the firebox, flue, damper, and any factory-built fireplace components to see what’s changed since last year, and we check the chase cap and crown when they’re accessible. In older Sharon Hill homes this often catches moisture damage before it turns into a masonry repair.

Level 2 Inspection
A Level 2 inspection is the camera-and-more inspection. It’s what you want after a fireplace insert is installed, after a chimney changes hands, or when something just isn’t drafting right. On these prefab chases, the camera is the difference between guessing and knowing – it lets us see past the appliance and into the flue behind it. We include camera inspection and a photo report, so you see what we see.

Creosote Removal
Creosote isn’t one thing. First-degree creosote brushes off easily; the glazed second- and third-degree creosote in a flue that was sized for coal, not today’s appliance, needs more care. When a flue is undersized for what’s now sitting in front of it, we don’t just brush and move on. We inspect. If we recommend something, it’s because the camera evidence supports it.

Soot Removal
Soot settles into the firebox, the smoke shelf, and the flue throat. A proper cleaning pulls it out without spreading it through the house. In these tight Sharon Hill rowhouses, where rooms are small and doors are close, containment matters more than in a wide-open suburban home. We take it seriously.
Trusted Brands We Service in Sharon Hill
We work with professional-grade product lines because the parts on a chimney are not a good place for hardware-store substitutes. DuraFlex for flexible liner retrofits, HeatShield for ceramic liner resurfacing, and Gelco and Famco for caps and covers – these are the names a chimney specialist specifies. We work with Olympia Chimney components and Copperfield-sourced parts, and we can tell you exactly what we’re installing and why. We don’t stock parts on shelves; we source the right component for the job. If your chase cap is the wrong brand for your insert, that gap is the problem to close. We can identify what’s actually there and match it properly.
Common Chimney Sweep Problems We See in Sharon Hill Homes
- The factory-built blind spot. A homeowner assumes the factory-built fireplace needs no service because nothing looks old. Meanwhile the original coal-era flue behind the insert spalls and cracks quietly, and nobody sees it until there’s a draft problem or worse.
- Mismatched chase caps and dampers. A top-sealing damper or chase cap installed for one insert brand gets paired with a different one. The result is draft loss and smoke rollback into the room whenever you crack the damper.
- Glazed creosote left behind. First-degree creosote gets brushed and forgotten. The glazed second- and third-degree creosote stays put because nobody ran a camera or a Level 2 on the prefab chase.
- Freeze-thaw on century-old brick. This part of Delaware County is humid and damp, with freeze-thaw winters and muggy summers that push crown cracking, spalling brick, and mortar joint decay. The masonry around a newer insert is often the weakest link.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Sweep in Sharon Hill, PA
Pricing is set per job by a written estimate, but here are the typical ranges we see in this market. A standard annual sweep and Level 1 inspection in Sharon Hill usually runs $150 – $280. A Level 2 inspection with camera work typically runs $250 – $450. Creosote removal runs $200 – $500 depending on how much glazed creosote is present. Soot removal and fireplace cleaning typically run $150 – $300. Liner work and masonry repairs are quoted separately once we know what’s behind the insert. What moves the number: how many flues, how much creosote, whether the chase cap is accessible, and whether the masonry needs work. For a twin or rowhouse, both sides of the party-wall stack may need checking. If you want a number, call (833) 432-4886. Estimates are free.
We Also Serve Cities Near Sharon Hill
We work across the nearby boroughs as well: Collingdale, Colwyn, Aldan, and Clifton Heights. If you’re just outside Sharon Hill and want to know whether we cover your street, give us a call and we’ll tell you straight. The same shared party-wall stacks and old coal-era flues show up in these towns too, and a Sharon Hill customer in a twin often lives a few doors from a Collingdale neighbor with the exact same chase.
Serving Sharon Hill, PA – Our Local Coverage Area
We serve Sharon Hill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Sweep in Sharon Hill
Yes, and probably more than you think. The inset appliance can be idle while the older flue behind it continues to spall, crack, and let moisture in – and an annual Level 1 inspection catches that. A chimney that sits unused can also collect damp debris and corroded parts. Call (833) 432-4886 for a free estimate.
You find the data plate. Most inserts carry a manufacturer plate, usually on the unit or behind a panel, and that’s the first thing our technicians pull. Famco, Gelco, Olympia, and DuraFlex components are common in this housing stock. We can’t identify a brand over the phone; we can at the property. Call (833) 432-4886.
The smoke rollback is usually a draft problem, not a visible-damage problem. A mismatched cap or damper, or a flue liner sized for the original coal flue rather than the insert’s spec, will cause smoke to spill into the room while the chase exterior looks perfectly normal. A Level 2 inspection is how you find it. Call (833) 432-4886.
First-degree creosote is a flaky, easy-to-brush layer. The glaze you’re seeing is second- or third-degree creosote, a harder, tar-like deposit that brushing won’t remove. In an undersized coal flue, it forms faster and sits deeper. A camera inspection tells you which you’ve got. Call (833) 432-4886.
A Level 1 is the annual check – firebox, flue, damper, insert components, whatever’s accessible. A Level 2 is required after a new install or a change of use, and it’s what you want any time there’s a draft complaint, a suspected problem, or a chase cap and liner mismatch. When in doubt, the camera settles it. Call (833) 432-4886.
Ready for a Sweep? Call Us
Whether your Sharon Hill home has an original coal-era flue or a factory-built insert in an old brick chase, we want to see it before the heating season starts. We’ll bring the camera, show you what’s going on, and tell you what can safely wait and what can’t. Call (833) 432-4886 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Fishtown.