Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Sharon Hill
If you’re searching for chimney cap and crown work in Sharon Hill, you’ve probably noticed water staining on a ceiling, a loose cap tilting on the stack, or mortar crumbs on the roof after a cold snap. We know this borough well. Sharon Hill sits close to Philadelphia, and its dense rows of older homes on narrow blocks along Chester Pike and the side streets off Sharon Avenue mean roof access is tight and stacks are packed together. Our technicians have up to 13 years of experience reading exactly what these chimneys are trying to tell homeowners. Call (833) 432-4886 to set up a free estimate in Sharon Hill.
Why Sharon Hill Homeowners Call Chimney Sweep Fishtown for Chimney Cap & Crown
Sharon Hill’s housing stock is mostly rowhouses and twins built in the early to mid-1900s, and their chimney flues were sized for coal and early oil heat, not modern wood inserts or gas appliances. That changes what a cap-and-crown visit actually involves. On a lot of these borough homes, the top of the chimney is the entry point for a bigger conversation about the flue itself.
We’re not a general handyman outfit that sweeps and moves on. We handle the whole chimney system, from sweep to rebuild, so when we open up a crown or pull a worn cap, we can follow the problem down to the liner and smoke chamber in the same visit. That’s why Sharon Hill homeowners keep our number.
Our technicians work with professional-grade product lines, including HeatShield, Gelco, Olympia Chimney, and Famco, so you know what’s going on your chimney has a name and a specification you can look up. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Response to Sharon Hill is quick. These are close-in streets, and we know the parking and roofline situation.
We won’t tell you that you need a full rebuild if a coating and a proper cap will hold the stack together another decade. That plain answer is the reason people around here call back.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Sharon Hill
We cover every cap and crown job these older brick chimneys throw at us. Here’s what each one involves in a Sharon Hill context.
Cap Installation
On an old coal-era stack, a properly fitted cap keeps rain, leaves, and birds out of a flue that was never designed for modern moisture loads. We size the cap to the actual tile opening, not an off-the-shelf guess, and set it so it sheds water away from the crown. On a shared party-wall stack, the cap setup has to account for both flues, which is where careful measuring matters most.

Cap Replacement
A cracked or missing cap lets water straight into a coal-era flue, and the freeze-thaw cycle does the rest. We replace caps on brick stacks and prefab chases alike, pulling the old unit, checking the flashing and chase top, and fitting a new cap from a line like Gelco or Famco. On a rowhouse, we check both sides of a shared stack before we consider the job done.

Crown Repair
The crown is the concrete or mortar cap at the very top of the stack, and it takes the worst of the weather. A poured or mortared crown on original brick spalls and separates from the flue tile when the mortar wasn’t mixed for freeze-thaw cycling, which is common on Sharon Hill’s older roofs. We rebuild the crown so it slopes and seals properly against the flue tile, using materials suited to this climate rather than the coal-era recipe that failed.

Crown Coating
When the crown is cracked but still structurally sound, a coating can seal it without a full rebuild. Not every crown is a candidate. We check for loose brick and soft mortar first, and coat only where the base is solid. On these damp summers and freezing winters, a good coating buys real years of protection when it’s applied to a crown that can hold it.
Our chimney cap & crown team also handles multi-flue caps and custom caps where a stock unit won’t fit, which comes up often on the twins and rowhouses packed along these narrow lots.
Trusted Brands We Service in Sharon Hill
We name the materials we use. On a larger crown rebuild or a flue restoration uncovered during cap work, we reach for HeatShield ceramic resurfacing, and for flexible liner retrofits we use DuraFlex, the preferred fit for older lined chimneys where a rigid liner can’t make the bend. Caps come from professional lines such as Gelco, Famco, and Olympia Chimney, brands that chimney pros specify, not hardware-store substitutes. We don’t claim to stock parts locally. We specify the right part for your stack, source it through trusted professional distributors, and get it installed. One call covers the whole chimney, and you get a written estimate before any work starts.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Sharon Hill Homes
The chimneys in this borough fail in a few recognizable ways. Here’s what we watch for on the rooflines around here.
- Factory-built caps cracking at the seam. On a mid-century prefab chase, the cap can split and let water wick into the flashing, rusting the chase top. Left alone, that rust spreads into the chase framing.
- Spalling, separated crowns on original brick stacks. The mortar on coal-era brick was never mixed for freeze-thaw cycling, so the crown separates from the flue tile and lets water in at the joint. That’s the start of the decay, not the end of it.
- Missing or undersized caps on shared party-wall flues. On a shared stack, a bad cap allows cross-draft between two units, pulling smoke and creosote odor from one firebox into the neighbor’s. It’s a frustrating problem that a properly sized cap solves.
- Damp summers and freezing winters working the brick. This humid Mid-Atlantic climate accelerates spalling, mortar joint decay, and crown cracking. A crown that looked fine in July can be shedding material by February.
Pricing for Chimney Cap & Crown in Sharon Hill, PA
We give honest ranges so you can plan. A typical cap installation in Sharon Hill runs $250 to $650, depending on flue count and whether it’s a stock or custom fit. Cap replacement usually lands in the same range, with a bit more if the old unit is seized or the chase top needs repair. Crown coating runs about $350 to $700, while a full crown repair or rebuild typically runs $550 to $1,200, driven by the size of the stack and how much loose brick needs to come out first.
Multi-flue and custom caps sit at the higher end because they’re measured and built to the original brick dimensions. What moves the number most is the condition underneath: a crown that’s a candidate for coating costs far less than one that needs a pour. We set the final price per job with a written estimate, and the estimate is free.
| Service | Typical Sharon Hill Range |
|---|---|
| Cap installation | $250 – $650 |
| Cap replacement | $250 – $650 |
| Crown coating | $350 – $700 |
| Crown repair or rebuild | $550 – $1,200 |
| Multi-flue or custom cap | At the higher end, priced to the stack |
We Also Serve Cities Near Sharon Hill
The rowhouses and twins in this corner of Delaware County share a lot of the same chimney problems, so if you’re just outside the borough line, we can help. We work in Collingdale, Colwyn, Aldan, and Clifton Heights as well, and the cap-and-crown work is much the same on those older stacks. If your neighbors already have our number, that’s fine. Call us when you’re ready.
Serving Sharon Hill, PA – Our Local Coverage Area
We serve Sharon Hill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Sharon Hill
Prefab fireplaces and chases still have caps and crowns that weather, and a factory-built cap can crack at the seam and wick water into the flashing even when the fireplace inside looks fine. Newer doesn’t mean protected. We inspect the chase top, flashing, and cap on every visit, because the water damage happens up top before you ever see a stain inside. Call (833) 432-4886 for a free estimate in Sharon Hill.
On a shared party-wall stack, each flue needs its own cap, because a missing or undersized cap on one side allows cross-draft that pulls smoke and odor into the neighbor’s unit. If you have a twin or rowhouse here, we check both addresses on the stack before signing off, since a defect on one side can quietly affect the other. If you’re unsure which flues you own, that’s exactly what the inspection sorts out. Call (833) 432-4886 and we’ll take a look.
Crown coating seals a crown that is cracked but still structurally sound, while crown repair rebuilds a crown that has spalled or separated from the flue tile. Coating costs less, but only works when the base is solid, so we check for loose brick and soft mortar first. On the coal-era stacks here, a crown that’s already shedding material usually needs repair, not a coat. Call (833) 432-4886 for an honest read on your crown.
A cap matters even if you rarely burn, because its main job is keeping rain, animals, and debris out of the flue. On a coal-era flue that was never sized for modern moisture, water intrusion accelerates spalling and mortar decay whether or not there’s a fire in it. The cap is cheap protection against expensive masonry later. Call (833) 432-4886 to get your cap checked.
A failing crown lets water into the flue, and moisture combined with creosote from any wood burning creates a sticky, corrosive mess that’s hard to sweep clean. The bigger issue in these older Borough flues is that they were sized for coal, so wood smoke moves differently and deposits more. When we open up a crown, we typically find the flue itself needs a look. Call (833) 432-4886 for a free estimate and a straight answer on what you actually need.
Every cap and crown job in Sharon Hill starts with a look, not a sales pitch. Call (833) 432-4886 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Fishtown.