Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Liner & Rebuild for Fishtown Homeowners
Fishtown’s rowhouses were built for coal, and most flues here were never lined for the way people burn wood today. That gap is where chimney fires and carbon monoxide problems start. A properly sized stainless liner contained inside a sound masonry chase is what makes a fireplace safe to use, and when the chase itself is cracked or spalling, resurfacing or rebuilding is the fix that lasts. Our technicians have up to 13 years of experience and handle the whole job: sweep, camera inspection, liner, cap and crown, and rebuild. Call (833) 432-4886 and we’ll book a free estimate. We answer 24/7.
What Our Chimney Liner & Rebuild Service Includes
Stainless Steel Liner
A stainless steel liner is a rigid or semi-rigid flue pipe dropped inside your existing chimney to carry smoke and gases safely to the top. You need one when the clay tiles are cracked, when the flue is unlined, or when a new stove or insert produces more heat than the old flue was built for. We size the liner to the appliance, not to whatever fits, and we insulate it so the flue stays warm and draft stays steady.
Flexible Liner
Flexible liners bend around offsets and tight turns that rigid pipe can’t negotiate, which is most of what we find in older Fishtown homes. They’re the right call when the chimney has a jog in it or the flue is too narrow for a rigid section. We use DuraFlex flexible liner systems for these retrofits because they’re built for exactly this kind of work and hold up to the heat cycling a wood fireplace puts them through.
Liner Replacement
Replacing a liner means pulling the old failed pipe or deteriorated clay out and putting a new, correctly sized liner in its place. This is the job when a previous liner has cracked, separated at a joint, or was never the right size for the appliance in the first place. We inspect with a camera before we recommend anything, show you the footage, and tell you plainly whether the old liner can stay or has to go.
Partial Rebuild
A partial rebuild addresses the section of chimney above the roofline when that’s where the damage sits: loose brick, failed mortar joints, a crumbling crown, or a flue tile that’s cracked at the top. It’s the right scope when the section below the roofline is still sound and doesn’t need to come down. Matching the new masonry to the existing brick and repointing the joints properly is the difference between a repair that holds and one that fails in a few winters.
Full Chimney Rebuild
A full rebuild tears the chimney down to a sound base and builds it back up, which is what a chimney needs when the damage runs the whole height of the stack. Leaning chimneys, widespread spalling brick, and a chase that’s pulled away from the house all point here. We rebuild the full stack, set a new crown, and cap it so the next owner doesn’t inherit the same problem. If you’re weighing liner work against a rebuild, our chimney liner & rebuild page walks through the difference.
Liner Repair
Liner repair is the middle path: fixing a liner that’s damaged but not beyond saving, rather than replacing the whole run. When the flue tiles have cracks and gaps but the structure around them is sound, we resurface with HeatShield, the ceramic system designed to seal and restore a deteriorated flue from the inside. It’s a specialized application most general handymen aren’t trained to do, and it can save a chimney that would otherwise need a full tear-out.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Liner & Rebuild
We name the materials we use because you can look them up yourself. DuraFlex flexible liner systems are what we reach for on retrofits where the flue has offsets or tight clearances that rigid pipe won’t clear, and we size them to the appliance so the draft stays reliable. HeatShield is our ceramic resurfacing system for restoring a deteriorated flue from the inside, and applying it correctly takes product-specific training rather than a general repair background.
For the parts above the flue, we install Gelco and Famco caps and covers, the professional-grade lines that hold up to weather instead of the box-store substitutes that rust out in a few seasons. Our components come through Copperfield, the professional distributor that certified sweeps order from, so what goes on your chimney is what the trade actually specifies. Whether you have a DuraFlex liner in place, a HeatShield-treated flue, or a chimney with no liner at all, we can help.
Signs You Need Chimney Liner & Rebuild Right Now
- White staining or crumbling on the chimney’s exterior. That chalky residue is often efflorescence, a sign moisture is moving through the masonry. Left alone, freeze-thaw cycles in a Philadelphia winter break the brick down further and turn a repointing job into a rebuild.
- Smoke rolling back into the room. A fireplace that smokes when you light it usually has a draft problem, and a cracked or undersized liner is a common cause. It also means combustion gases aren’t leaving the way they should, and carbon monoxide has no smell to warn you.
- Visible cracks or gaps in the flue tiles. You’ll see these on a camera inspection, not from the hearth. A cracked flue tile lets heat and gases reach the masonry and the wood framing behind it, which is exactly the path a chimney fire takes into the structure.
- A chimney that leans or pulls away from the house. Movement like that points to a foundation or structural problem, not a cosmetic one. It needs eyes on it before the next burning season, and it’s not a job to defer.
- Loose brick or mortar on the roof or in the yard. Falling masonry is a hazard to anyone below and a sign the joints have failed. It also means water is getting in and the damage is getting worse with every rain.
Our Chimney Liner & Rebuild Process – Step by Step
- 1
Book the sweep and inspection. We schedule a sweep along with a full inspection so we’re looking at a clean flue, not a sooted one. Nothing gets recommended off a glance from the ground.
- 2
Camera inspection with a photo report. We run a camera the length of the flue and record what we find, cracks, gaps, offsets, and the condition of the crown and cap. You see the footage and the photos yourself, so the recommendation is something you can verify rather than take on faith.
- 3
A written scope and flat-price estimate. We put the findings in writing and price the job as a flat rate agreed before we book, so there’s no surprise on the invoice. If part of the work can wait, we say so.
- 4
The work itself. Depending on scope, that could be a DuraFlex liner install, a HeatShield resurfacing, a partial rebuild above the roofline, or a full rebuild from the base to a new crown. We handle the whole system, so you’re not calling a second contractor to finish what the first one started.
- 5
Final inspection and photo report. We check the finished liner, cap, and crown, then hand you photos of the completed work for your records. If you’re selling the house or buying one, that documentation is worth having.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Fishtown?
Estimated costs in Fishtown depend heavily on scope, because a liner job and a full rebuild are very different projects. Here are typical ranges for the common scenarios, priced per job by a written estimate:
| Work | Typical Estimated Range |
|---|---|
| Liner repair / resurfacing (HeatShield) | $1,200 – $2,600 |
| Stainless or flexible liner replacement | $2,000 – $4,500 |
| Partial rebuild above the roofline | $3,000 – $7,500 |
| Full chimney rebuild | $9,000 – $20,000+ |
What moves the number: the height of the chimney, whether the flue has offsets, the condition of the masonry, and whether a new appliance is involved. What keeps you from overpaying is the written scope and the camera footage behind it, so you know exactly what’s being fixed and what isn’t. Our estimate is free, and nothing is recommended without evidence you can see for yourself. If part of the work can safely wait, we’ll tell you that too. Call (833) 432-4886 for an exact quote.
Chimney Liner & Rebuild Near Fishtown – Our Service Area
We serve homeowners across Chimney Sweep Fishtown and the surrounding neighborhoods, including Kensington, Port Richmond, Northern Liberties, and Hunting Park, plus nearby communities like chimney liner & rebuild in Aldan, Sharon Hill, Collingdale, Clifton Heights, Drexel Hill, Colwyn, and Haverford College. Most jobs in these areas are booked within a few days of your call. Fast dispatch from 7am to 7pm, Sunday through Friday.
Serving Fishtown, PA – Our Local Coverage Area
We serve Fishtown and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Liner & Rebuild in Fishtown
A chimney liner is the pipe or flue lining that carries smoke and gases safely up and out of your house. It’s what keeps the heat and combustion byproducts away from the masonry and framing that surround the chimney. If your flue is unlined or the clay tiles are cracked, you need a liner before you burn again.
A liner replacement usually takes a day, and a liner repair or resurfacing is typically a day or less. A partial rebuild runs longer, and a full rebuild is a multi-day project scheduled in advance. We’ll tell you the expected timeline in your written estimate.
Liner work in Fishtown typically ranges from about $1,200 to $4,500 depending on whether you need repair or a full replacement. The written estimate sets the final price, and the estimate itself is free. Call (833) 432-4886 for an exact quote.
Yes. We install and service DuraFlex flexible liners and apply HeatShield ceramic resurfacing, along with Gelco, Famco, Olympia Chimney, and Copperfield components. Whether you have one of those in place or a flue with no liner at all, we can help.
Same-day service is often possible, and we’ll tell you on the call whether we can fit you in. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening.
Yes, the work carries a satisfaction guarantee. We put the scope in writing and include a photo report of the finished job. If something isn’t right, call us and we’ll make it right.
Clear the hearth and the area around the fireplace, and make sure we can get to the chimney from the roof. If you’re having a rebuild, keep the driveway clear for the crew’s access. You don’t need to do anything else; we handle the rest.
Schedule Your Chimney Liner & Rebuild Service in Fishtown Today
If your chimney is unlined, cracked, or showing signs it needs work, don’t put another fire in it until it’s checked. Call (833) 432-4886. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. You’ll get a free, no-obligation estimate with camera footage and a written scope before anything is booked. One call covers the whole chimney.
Written by the team at Chimney Sweep Fishtown.